安科瑞 劉秋霞

Application of Acrel Medical Isolated Power Supply System in Luanda General Hospital, Angola

摘要: 現代醫院的診斷和治療，離不開各種先進的醫療設備，而各種設備都離不開安全可靠的供電。很多手術往往長達數小時，手術過程中突然斷電的話后果不可想象；同時很多醫療器械都直接接觸或深入人體臟器，此時較小的漏電流都會威脅病人的生命安全。因此，針對醫院配電系統供電的連續性和安全性，國家相關標準作了明確要求，醫療2類場所重要設備須用IT系統供電，同時IT系統需要配置絕緣監測裝置。本文介紹了安科瑞醫療IT系統在安哥拉羅安達總醫院的應用。

Abstract: Diagnosis and treatment in modern hospitals are inseparable from advanced medical equipment, which are inseparable from safe and reliable power supply. Many operations often last for several hours, and the consequences of a sudden power failure during the operation are unimaginable. At the same time, many medical devices directly touch or penetrate into the human organs. At this time, the very small leakage current will threaten the life of the patient. Therefore, the national standards have made clear requirements, medical group 2 locations must be powered by IT system. This article introduces the application of Acrel Medical IT System in Luanda General Hospital, Angola.

關鍵詞: 醫療IT，絕緣監測裝置，報警顯示儀。

Keywords: Medical IT system, Insulation monitoring device, Alarm indicators.  

1.Project Overview項目概述

安哥拉羅安達總醫院是由中鐵四局承擔的中國援安哥拉羅安達總醫院改擴建項目，該項目使用了8套安科瑞醫療IT系統產品。主要包括：AITR系列隔離變壓器，AIM-M系列絕緣監測儀，AID系列報警顯示儀和AKH-0.66P26電流互感器。

Luanda General Hospital in Angola is a China-aided reconstruction and expansion project of Luanda General Hospital in Angola undertaken by China Railway Fourth Bureau. The project uses 8 sets of Acrel medical IT system products. They are AITR series isolation transformer, AKH-0.66P26 current transformer, AIM-M series insulation monitoring device, AID series remote alarm indicator and DC power supply unit.

2.Introduction of Medical Isolated Power Supply System 醫療IT系統介紹

隔離電源系統就是通過隔離變壓器將接地系統（TN-S系統）轉接成不接地系統（IT系統）來為重要的醫療設備供電。IT系統通過絕緣監測儀實現絕緣監測，通過絕緣故障產品進行絕緣故障定位。

The medical isolated power supply system is to switch the grounding system (TN-S system) into ungrounded system (IT system) through a medical isolation transformer to supply power for important medical equipment. The insulation monitoring device has the function of insulation monitoring and fault locator has the function of fault circuit locating.

3.Acrel Medical Isolated Power Supply System Solutions 安科瑞醫療IT解決方案

Acrel medical isolated power supply system is suitable for operating room, ICU, CCU and other medical group 2 locations providing safe and uninterruptible power supply. It mainly includes AITR series isolation transformer, AKH-0.66P26 current transformer, AIM-M series insulation monitoring device, AID series remote alarm indicator, DC power supply, ASG series test signal generator and AIL series insulation fault locator.

3.1 Acrel Medical Isolated Power Supply System for Operating Room 手術室配電解決方案

注：1.在手術室的配電解決方案中，AID系列外接報警與顯示儀應安裝于手術室內部情報面板上，或情報面板的旁邊（嵌墻安裝）。在手術過程中，由醫務人員來監視隔離電源系統的運行狀況。

   2.帶絕緣故障定位功能的方案中，如果需定位回路超過8路，可采用兩套AIL150定位儀來實現，其組合可以是AIL150-8型+AIL150-4型(可多定位12路)，或AIL150-8型+AIL150-8型（可多定位16路）。

Note: 1. For operating room, AID series alarm indicator should be installed on the intelligence panel inside the operating room, or next to the intelligence panel (wall mounted installation) so that medical personnel can immediately receive a notification when there is power supply failure.

2.In Option II，if the number of located channels is more than eight，two sets of AIL150 can be used. The combination can be AIL150-8 and AIL150-4 (up to 12 channels), or AIL150 -8 and AIL150-8 (up to 16 channels).

3.2 Acrel Medical Isolated Power Supply System for ICU and CCU  ICU,CCU配電解決方案

注：在重癥監護室的配電解決方案中，AID系列集中報警與顯示儀應該安裝在護士站內，由護士站的醫務人員來監視各隔離電源系統的運行狀況。

Note: For intensive care unit , AID series alarm indicator should be installed in the nurses 'station so that medical personnel can monitor the operating status of isolated power supply system.

3.3 Product Selection產品選型

4.Connection Diagram接線圖

5.Installation Photos 安裝圖片

6.Conclusion 總結

  經過擴改建以后，羅安達總醫院已成為安哥拉規模較大、硬件設施較好的醫院。而安科瑞醫療IT系統為該醫院的安全、連續供電提供了重要保障，合理改良了當地醫療條件，造福了當地人民。

After expansion and reconstruction, Luanda General Hospital has become the largest hospital in Angola. The Acrel medical IT system provides safe and realible power supply for hospitals,  effectively improving the local medical conditions and benefiting the local people.

Bibliography

1. IT System Insulation Monitoring Device and Fault Location System of Acrel. 2020

2. IEC 60354-7-710: 2002 Electrical installations of buildings-Part 7-710:Requirements for special installations or locations - Medical locations. 2002

3. IEC 61558-1-15:2011 Safety of transformers, reactors, power supply units and combinations thereof-Part 2-15: particular requirements and tests for isolating transformers for the supply of medical locations. 2011